Manualshelf

Owner's Manual

ManualsBrandsDell ManualsserversDell Open Automation
21222324252627282930
Bare Metal Provisioning (BMP) - Config | 29
• When the preconfiguration script completes, the start up configuration file is
automatically applied.
If a preconfiguration script file download is successful, the following SYSLOGs
display.
00:03:07: %STKUNIT0-M:CP %BMP-2-BMP_DOWNLOAD_START: The config
file download has started.
00:03:19: %STKUNIT0-M:CP %BMP-5-BMP_DWNLD_FILE_IS_SCRIPT_FILE:
The downloaded file is a script file.
00:03:19: %STKUNIT0-M:CP
%BMP-5-BMP_DWNLD_CONFIG_SCRIPT_SUCCESS: The config/script file
download is successful.
00:03:21: %STKUNIT0-M:CP %BMP-5-BMP_PRE_CONFIG_SCRIPT_BEGIN:
The Pre-Config Script has started to Execute.
After the preconfiguration script successfully executes, the startup configuration file
loads.
00:04:30: %STKUNIT0-M:CP %BMP-5-BMP_PRE_CONFIG_SCRIPT_END:
Pre-Config script completed with return status 0.
00:03:03: %STKUNIT0-M:CP %IFMGR-5-ASTATE_DN: Changed interface
Admin state to down: Ma 0/0.
00:03:03: %STKUNIT0-M:CP %IFMGR-5-OSTATE_DN: Changed interface
state to down: Ma 0/0.
00:03:03: %STKUNIT0-M:CP %SYS-5-CONFIG_LOAD: Loading
configuration file.
00:03:04: %STKUNIT0-M:CP %IFMGR-5-ASTATE_UP: Changed interface
Admin state to up: Ma 0/0.
If a post configuration script is present in the applied configuration file, it executes
and the following logs display:
00:04:22: %STKUNIT0-M:CP %BMP-5-BMP_POST_CONFIG_SCRIPT_BEGIN:
The Post-Config Script has started to Execute
.
.
00:05:15: %STKUNIT0-M:CP %BMP-5-BMP_POST_CONFIG_SCRIPT_END:
Post-Config script completed with return status 0.
If a post configuration script is not present in the applied configuration file, the
following logs display:
00:03:03: %STKUNIT0-M:CP %SYS-5-CONFIG_LOAD: Loading
configuration file.
00:03:04: %STKUNIT0-M:CP %IFMGR-5-ASTATE_UP: Changed interface
Admin state to up: Ma 0/0.
00:03:04: %STKUNIT0-M:CP %BMP-5-BMP_POST_SCRIPT_NOT_PRESENT:
The Post-Config Script is not present.
DHCP Offer Vendor-Specific Option for BMP
A vendor specific DHCP OFFER option (code 231) termed as fips-mode-enabled
has been introduced to configure the FIPS-mode for the system, so that BMP decides
on using the non-FIPS approved algorithms for image/config-file download process.
This option accepts the boolean type value TRUE/FALSE to enable/disable the
FIPS-mode. BMP uses this setting temporarily only for the image/config-file