Owner's Manual

46 | Bare Metal Provisioning (BMP) - CLI

www.dell.com | support.dell.com

Commands

• bmp logging

• reload conditional nvram-cfg-change

• reload-type

• script post-config

• show boot bmp

• show reload-type

• stop bmp

• verify

bmp logging

, MXL

Switch

Configure the syslog messages in a console while BMP is running.

Syntax

bmp logging {enable | disable}

Defaults

None.

Command Modes

EXEC

Parameters

Command

History

Usage

Information

• This command is applicable only when BMP is running and enables/disables the

syslog messages (with Severity level >2, critical).

• When BMP is not running, the following error message displays:

% Error: bmp process is not running.

enable Enables the syslog messages in the console while BMP is running.

disable Disables the syslog messages in the console while BMP is running.

Version 9.5(0.1) Introduced on the Z9500.

Version 9.5(0.0) Introduced on the S4810, S4820T, S6000, Z9000, and MXL.

Note: This CLI command is only available in BMP normal context, which is similar to

providing L option in the Factory-default context.