Owner's Manual

Bare Metal Provisioning 1.5 | 21
Figure 3-2. Factory-Default Startup Configuration Settings
Factory-Default Mode: Boot and Set-up Behavior
After a switch boots up, use the show users command to view the IP addresses
configured for connecting devices and the status of each connection; for example:
Figure 3-3. Displaying Connected Devices After Bootup
During the first ten minutes after authentication is enabled on the switch, access to
the system is not secured. No password is required as shown in Figure 3-4.
interface range GigabitEthernet 0/0 - 47 Interfaces boot up in:
no shutdown <----------------------------- no shutdown mode
switchport <------------------------------ Layer 2 mode
!
interface range TenGigabitEthernet 0/48 - 51
no shutdown
switchport
!
interface ManagementEthernet 0/0
ip address 192.168.0.1/24 <--------------- Temporary management IP address
no shutdown
!
ip telnet server enable
!
ip ssh server enable
!
protocol spanning-tree rstp
no disable
!
protocol lldp
no disable
advertise dot1-tlv port-vlan-id
advertise dot3-tlv max-frame-size
advertise management-tlv system-description system-name
advertise med
no disable
!
end
FTOS00:26:15: %STKUNIT1-M:CP %SEC-5-LOGIN_SUCCESS: Login successful for user
on vty0 (192.168.0.5)
FTOS#00:26:19: %STKUNIT1-M:CP %SEC-5-LOGIN_SUCCESS: Login successful for user
on vty1 (192.168.0.5)
FTOS#show users
Line User Host(s) Location
* 0 console 0 idle
2 vty 0 idle 192.168.0.5
3 vty 1 idle 192.168.0.5