Owner's Manual
44 | Bare Metal Provisioning CLI
www.dell.com | support.dell.com
Commands
• reload factory-default
• reload factory-default dhcp-client-mode
• reload factory-default dhcp-client-only-mode
• reload factory-default dhcp-server-mode
• reload-type
• show reload-type
• stop jump-start
reload factory-default
BMP 1.5 auto-configuration mode A: Reload the switch with the FTOS image stored
in the local flash and apply the factory-default startup configuration. A temporary
management IP address (192.168.0.1) is created.
Syntax
reload factory-default
Defaults
Loads the factory-default startup configuration file (see Example below).
Command Modes
EXEC Privilege
Command
History
Usage
Information
This is the reload mode when a new Dell Force10 switch (without BMP) arrives. You
can replace the temporary management IP address with a user-configured
management IP address. The IP address 192.168.0.1 continues to be active for ten
minutes. After ten minutes, a user-configured IP address is applied to the
management interface.
Version 8.3.5.0 Introduced on the S55.
Version 8.3.3.1 Introduced on the S60.