Owner's Manual

Bare Metal Provisioning CLI | 49
stop jump-start
z
BMP 2.0: Stop the switch from reloading in Jumpstart mode to prevent a loop from
occurring.
Syntax
stop jump-start
Defaults
None
Command Modes
EXEC Privilege
Command
History
Usage
Information
Use the stop jump-start command on a switch running BMP 2.0 if the switch enters
a loop while reloading in Jumpstart mode because it is continuously trying to contact
a DHCP server and a DHCP server is not found. The
stop jump-start command
stops the switch from connecting to the DHCP server. The startup configuration file
stored in the local flash on the switch is loaded as part of the
stop jump-start
command.
Version 8.3.11.4 Introduced on the Z9000.
Version 8.3.10.1 Introduced on the S4810.