Service Manual

Related Commands
• reload-type — allows you to congure the reload-type options in reload-type sub command mode.
• show reload-type — displays the current Reload mode (BMP mode or Normal mode).
reload conditional nvram-cfg-change
After saving the BMP conguration, to perform a reload on the chassis due to conguration changes that changes the NVRAM content,
use this command.
S4810, S4820T, S3048–ON, S3100 series, S4048–ON, S5000,
S6000, S6000–ON, Z9100–ON, Z9500, C9010, and MXL
Switch
Syntax
reload {conditional nvram-cfg-change | no-confirm [discard-running]}
Parameters
condtional
nvram-cfg-
change
Reload the chassis only if there are any NVRAM conguration changes.
no-confirm
Reload the chassis after writing the running-config to startup-config without
prompting for further conrmation.
[discard-
running]
Discard writing the running-config to startup-config.
Defaults none
Command Modes EXEC
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced the no-confirm option.
9.9(0.0) Introduced on the C9010.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0P1) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048–ON.
9.8(0.0P2) Introduced on the S3048–ON.
9.7(0.0) Introduced on the S6000–ON.
9.6(0.0) Introduced on the S5000.
9.5(0.1) Introduced on the Z9500.
9.3(0.0) Introduced on the S6000.
9.2(0.0) Introduced on the MXL Switch.
9.1(0.0) Introduced on the Z9000 and S4810.
42 Bare Metal Provisioning CLI