Service Manual

config
VSN retrieves configuration information from the Hypervisor and implements any
necessary configuration changes automatically.
Defaults config
Command Modes HYPERVISOR
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.6(0.0) Introduced on the S5000.
9.2(0.0) Introduced on the MXL.
8.3.19.0 Introduced on the S4820T.
8.3.8.0 Introduced on the S4810.
Usage Information
You can use the mode command to change how virtual-server information is retrieved in an existing Hypervisor
session.
The following log messages display when you use the Hypervisor mode check option to retrieve configuration
information on virtual servers:
Dec 1 04:57:48: %STKUNIT0-M:CP %VSNMGR-5-VSN_VLAN_DISCOVERY: Te 0/35, Vlan:
4001-4008,4011-4012
Dec 1 04:56:46: %STKUNIT0-M:CP %VSNMGR-5-VSN_VLAN_WITHDRAWAL: Te 0/35, Vlan:
4001-4008,4011-4012
package install
Installs an Open Automation package, such as VSN. This command downloads the package from the specified location and installs it in the
internal flash memory on a switch.
S4810, S4820T, S5000, and MXL Switch
Syntax
package install location
Parameters
location
Enter the location where you want to install an Open Automation package, where location
is one of the following values:
• flash://filename — Installs the VSN package file stored in flash memory on the
switch.
•
ftp://userid:password@host-ip-address/file-path — Logs in and
installs VSN from a file stored on an FTP server.
• tftp://host-ip-address/file-path — Installs VSN from a file stored on a
TFTP server.
• nfsmount://filepath — Copies from a file stored on an NFS mount file system.
128 Virtual Server Networking CLI