Service Manual

config-scr-download
Allows you to specify whether the configuration or script file needs to be downloaded.
S4810, S4820T, S3048–ON, S3100 series, S4048–ON,
S4048T–ON, S5000, S6000, S6000–ON, S6010–ON, S6100–
ON, Z9100–ON, Z9500,
C9010, IOA, and MXL
Syntax
config-scr-download { enable | disable }
To reset the download option, use the no config-scr-download { enable | disable } command.
Parameters
config-scr-
download
{enable}
Enable downloading a configuration file or pre–configuration script from the DHCP / file
servers.
config-scr-
download
{disable}
Disable downloading a configuration file or pre–configuration script from the DHCP/ file
servers.
Defaults none
Command Modes RELOAD-TYPE CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.1) Introduced on the S4048T–ON and S6010–ON.
9.10(0.0) Introduced on the S6100–ON.
9.9(0.0) Introduced on the C9010.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0P1) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048–ON.
9.8(0.0P2) Introduced on the S3048–ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000–ON, Z9000, Z9500, IOA, and
MXL.
Usage Information
For an initial setup, the config-scr-download parameter of the reload-type command is enabled. After
the configuration file successfully downloads, the config-scr-download parameter is automatically disabled.
You can enable it again using the
reload-type command.
Related Commands
• reload-type — allows you to configure the reload-type options in reload-type sub command mode.
Bare Metal Provisioning CLI 43