Administrator Guide

Version Description
9.5(0.0) Introduced on the S4810, S4820T, S6000, Z9000, and MXL.
Usage
Information
This command is applicable only when BMP is running and enables or disables the
syslog messages (with a Severity level >2, critical).
When BMP is not running, the following error message displays: % Error: bmp
process is not running.
NOTE: This CLI command is only available in BMP normal context, which is
similar to providing the L option in the Factory-default context.
boot-type
Allows you to configure the reload type.
S4810, S4820T, S5000, S6000, S6000–ON, Z9000, Z9500, IOA, and MXL
Syntax
boot-type { bmp-reload | normal-reload }
To reset the boot-type mode, use the no boot-type { bmp-reload |
normal-reload } command.
Parameters
bmp-reload
Reloads the system in BMP mode. After performing the
reload, the system retrieves the Dell Networking OS image
and startup-configuration files from the flash.
normal-
reload
Reloads the system in manual interactive mode.
Defaults none
Command
Modes
RELOAD-TYPE CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000–
ON, Z9000, Z9500, IOA, and MXL.
Related
Commands
• reload-type — allows you to configure the reload-type options in reload-type
sub command mode.
44
Bare Metal Provisioning CLI