Administrator Guide

dhcp-timeout

Allows you to configure the DHCP timeout limit.

S4810, S4820T, S5000, S6000, S6000–ON, Z9000, Z9500, IOA, and MXL

Syntax

dhcp-timeout minutes

To reset the DHCP time out limit, use the no dhcp-timeout minutes

command.

Parameters

dhcp-timeout

minutes

Configure the DHCP timeout (in minutes) after which the

BMP exits. The range is from 0 to 50. If you enter a range of

0, the timeout is 0 (no limit).

NOTE: Dell Networking recommends setting the value to

2 or higher.

Defaults Disabled

Command

Modes

RELOAD-TYPE CONFIGURATION

Command

History

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000–

ON, Z9000, Z9500, IOA, and MXL.

Commands

• reload-type

— allows you to configure the reload-type options in reload-type sub

command mode.

• show reload-type — displays the current Reload mode (BMP mode or Normal

mode).

Bare Metal Provisioning CLI