Concept Guide

NOTE:
The key (property ID) in the BGP conguration is of the form:Id = "1-1-vrf-1";AddressFamily-ExtAsNumber-
VRFName.Example:
For an ASN 100 on default-VRF (IPv4) it will be 1-100-default
For IPv6 context, it will be 2-100-default (corresponds to Router bgp 100 Address-family
ipv6 unicast)
Powershell Cmdlets and OMI Compatibility Matrix
This section describes the list of DesiredStateConguration (DSC) resource cmdlets supported in OMI.
Table 2. Powershell Cmdlets and OMI Compatibility Matrix
Cmdlets Description Version Support
Get-DscConfiguration
Gets the current conguration of the nodes. 4.0 and 5.0
Get-
DscLocalConfigurationManager
Gets Local Conguration Manager settings
and states for the node.
4.0 and 5.0
Get-DscResource
Gets the DSC resources present on the
computer.
4.0 and 5.0
Remove-DscConfigurationDocument
Removes a conguration document from
the DSC conguration store.
Not Supported
Restore-DscConfiguration
Reapplies the previous conguration for the
node.
4.0 and 5.0
Stop-DscConfiguration
Stops a conguration job that is running. 4.0 and 5.0
Test-DscConfiguration
Tests whether the actual conguration on
the nodes matches the desired conguration
4.0 and 5.0
Set-
DscLocalConfigurationManager
Applies Local Conguration Manager
settings to nodes.
4.0 and 5.0
Start-DscConfiguration
Applies conguration to nodes. 4.0 and 5.0
Update-DscConfiguration
Runs the existing conguration on a
computer.
4.0 and 5.0
Get-DscconfigurationStatus
Retrieves data about completed
conguration runs.
Not Supported
Publish-Dscconfiguration
Publishes a DSC conguration to a set of
computers, but does not apply it.
Not Supported
64 Open Management Infrastructure