Service Manual
Parameters
username
username
Enter the keyword username then the name of the user to
access the script. The maximum length is 16 characters. The
default username is the user configuring the CLI.
privilege
privilege
Enter the keyword privilege then the privilege level to
run the scripts. The range is from 1 to 15.
Defaults none
Command Modes SCRIPT EVENT HANDLER CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.8(0.0P5) Introduced on the S4048–ON.
9.8(0.0P2) Introduced on the S3048–ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000–
ON, Z9000, Z9500, and MXL.
Usage Information
• Only the person who configures the scheduled scripts (or a higher privileged
user) can change them.
• If you do not provide the username, the system uses current session username.
If the script is triggered from the console, the system uses the Dell Networking
OS default username (smartuser).
• The privilege level mentioned should be equal to or less than the user who is
configuring the command.
Example
username smartuser privilege 15
Smartuser is the default username used for running the scripts on the device,
which takes the privilege based on the user session.
username
Configure an additional username and password to run the scripts on a switch. Use the username and
password to log in to a UNIX shell and apply the read-write privileges assigned to the username when a
script runs.
S4810, S4820T, S3048–ON, S4048–ON, S5000, S6000, S6000–ON, Z9500,
C9010, and MXL
Syntax
username name password password
116
Smart Scripting CLI