Service Manual

10
Virtual Server Networking CLI
The virtual server networking CLI is supported on the S4810, S4820T, S5000, and MXL switch platforms.
NOTE: VSN is only supported on standalone switches; it is not supported in stacked configurations.
access
Configure the connection to access a hypervisor.
S4810, S4820T, S5000, and MXL Switch
Syntax
[no] access url username name password password
Parameters
url
Enter the URL location of the desired hypervisor.
• For a VMware hypervisor, enter, https://[ip-
address]/sdk/vimService username [name]
password [password]
• For a Xen hypervisor, enter, http://ip-address
username [name] password [password]
username name
Enter the keyword username then the name for
authentication.
password
password
Enter the keyword password then the password in clear
text for authentication.
Defaults none
Command Modes HYPERVISOR
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.6(0.0) Introduced on the S5000.
9.2(0.0) Introduced on the MXL switch.
8.3.19.0 Introduced on the S4820T.
Virtual Server Networking CLI
127