Service Manual

• show reload-type — displays the current Reload mode (BMP mode or Normal

mode).

reload conditional nvram-cfg-change

After saving the BMP configuration, to perform a reload on the chassis due to configuration changes that

changes the NVRAM content, use this command.

S4810, S4820T, S3048–ON, S4048–ON, S5000, S6000, S6000–ON, Z9500,

C9010, and MXL Switch

Syntax

reload conditional nvram-cfg-change

Defaults none

Command Modes EXEC

Command History

This guide is platform-specific. For command information about other platforms,

see the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.9(0.0) Introduced on the C9010.

9.8(0.0P5) Introduced on the S4048–ON.

9.8(0.0P2) Introduced on the S3048–ON.

9.7(0.0) Introduced on the S6000–ON.

9.6(0.0) Introduced on the S5000.

9.5(0.1) Introduced on the Z9500.

9.3(0.0) Introduced on the S6000.

9.2(0.0) Introduced on the MXL Switch.

9.1(0.0) Introduced on the Z9000 and S4810.

8.3.19.0 Introduced on the S4820T.

Usage Information

To upgrade any NVRAM changes to the chassis caused by the following CLI

commands, use the reload conditional nvram-cfg-change command on a

switch running BMP.

• stack-unit {unit} stack-group

• stack-unit {unit} port {fanout-portid} portmode quad

• asf-mode

• cam-acl

• buffer-profile

Bare Metal Provisioning CLI