Service Manual
script post-config
To run the post-configuration script after the preconfiguration script is executed during the BMP reload,
ensure that this command is present in the startup-configuration.
S4810, S4820T, S3048–ON, S4048–ON, S5000, S6000, S6000–ON, Z9500,
C9010, and MXL
Syntax
script post-config {script-name}
Parameters
scriptname
Enter the name of the script to run after the BMP start-up
configuration is applied.
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.8(0.0P5) Introduced on the S4048–ON.
9.8(0.0P2) Introduced on the S3048–ON.
9.7(0.0) Introduced on the S6000–ON.
9.6(0.0) Introduced on the S5000.
9.5(0.1) Introduced on the Z9500.
9.3(0.0) Introduced on the S6000.
9.2(0.0) Introduced on the MXL switch and S4820T.
9.1(0.0) Introduced on the Z9000 and S4810.
show boot bmp
Displays the current state of the BMP process.
S4810, S4820T, S3048–ON, S4048–ON, S5000, S6000, S6000–ON, Z9500,
C9010, and MXL
Syntax
show boot bmp
Defaults none
50
Bare Metal Provisioning CLI