Service Manual
with Type, Hardware, Serial Number, Service Tag and OS
Version.
Defaults none
Command Modes RELOAD-TYPE CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.8(0.0P5) Introduced on the S4048–ON.
9.8(0.0P2) Introduced on the S3048–ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000–
ON, Z9000, Z9500, IOA, and MXL.
Related
Commands
• reload-type — allows you to configure the reload-type options in reload-type
sub command mode.
• show reload-type — displays the current Reload mode (BMP mode or Normal
mode).
verify
Validates the software image on the flash drive after the image is transferred to the system but before the
image is installed.
S4810, S4820T, S3048–ON, S4048–ON, S5000, S6000, S6000–ON, Z9500,
C9010, IOA, and MXL
Syntax
verify {md5 | sha256} [flash://] img-file [hash-value]
Parameters
md5 MD5 message-digest algorithm.
sha256 SHA256 Secure hash algorithm.
[flash://] flash (Optional) Specifies the flash drive. The default is to use the
flash drive. Enter the filename of the image.
img-file Enter the name of the Dell Networking software image file to
validate.
hash-value (Optional) Specify the relevant hash published on the Dell
support page.
Defaults none
56
Bare Metal Provisioning CLI