Setup Guide

Bare Metal Provisioning CLI
Bare metal provisioning commands are supported on the S3048–ON, S3100 Series, S4048–ON, S5048F-ON, S6000, S6000-ON, S6010–
ON, S6100–ON, C9010, and Z9100–ON platforms.
In a data center network, BMP automates conguring and updating the switches, ensuring standard congurations across the installed
devices.
To set up a single switch or a stack of switches with minimal eort, use the auto-conguration function.
On S3048–ON, S3100 Series, S4048–ON, S5048F-ON, S6000, S6000-ON, S6010–ON, S6100–ON, C9010, and Z9100–ON platforms
running BMP:
• Species boot images and conguration les in a dynamic host conguration protocol (DHCP) server.
• Supports pre–conguration and post–conguration scripts to automatically load predened congurations and Dell EMC Networking
OS images using DHCP and common le transfer mechanisms.
• Allows switch access through all ports (management and user ports) with or without a DHCP-based dynamic IP address conguration
of the switch.
• Automatically downloads conguration les from a le server and applies them to the switch or stack.
• Boots up in Layer 3 mode with interfaces already in No Shutdown mode. Some basic protocols are enabled to protect the system and
network.
Topics:
• auto-save
• bmp logging
• boot-type
• cong-scr-download
• dhcp-timeout
• relay
• reload conditional nvram-cfg-change
• reload-type
• retry-count
• script post-cong
• show boot bmp
• show cong
• show reload-type
• stop bmp
• vendor class identier
• verify
4
38 Bare Metal Provisioning CLI