Users Guide

stop bmp
To prevent an innite loop, stop the switch from reloading in BMP mode.
S4810, S4820T, S3048–ON, S3100 series, S4048–ON,
S4048T–ON, S5000, S6000, S6000–ON, S6010–ON, S6100–
ON, Z9100–ON, Z9500,
C9010, , IOA, FN-IOM, and MXL
Syntax
stop bmp
NOTE: This command replaces the stop jumpstart command.
Defaults none
Command Modes EXEC
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
The following is a list of the Dell EMC Networking OS version history for this command.
Version Description
9.10(0.1) Introduced on the S4048T–ON and S6010–ON.
9.10(0.0) Introduced on the S6100–ON.
9.9(0.0) Introduced on the C9010.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0P1) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048–ON.
9.8(0.0P2) Introduced on the S3048–ON.
9.7(0.0) Introduced on the S6000–ON.
9.6(0.0) Introduced on the S5000.
9.5(0.1) Introduced on the Z9500.
9.3(0.0) Introduced on the S6000. Replaces the stop jumpstart command.
9.2(0.0) Introduced on the Z9000, S4810, S4820T, and MXL switch. Replaces the stop
jumpstart command.
9.1(0.0) Introduced on the Z9000 and S4810. Replaces the stop jumpstart command.
Usage Information
If the switch enters a loop while reloading in BMP mode, use the stop bmp command on a switch running BMP.
A loop occurs when the switch is continuously trying to contact a DHCP server and a DHCP server is not found.
The stop bmp command stops the switch from connecting to the DHCP server. After you use the stop bmp
command, the next default reload type is a normal reload as indicated in the show reload-type or show
system brief commands.
54 Bare Metal Provisioning CLI