Dell OpenManage Deployment Toolkit Version 4.
What’s New The new features for this release include: Added support for the following operating systems: o Red Hat Enterprise Linux 6.2 (64-bit) o Red Hat Enterprise Linux 5.8 (32-bit and 64-bit) Deprecated the following operating systems: o Red Hat Enterprise Linux 6.1 (32-bit and 64-bit) o Red Hat Enterprise Linux 5.7 (32-bit and 64-bit) Supported Systems For a complete list of supported Dell PowerEdge systems, see the Dell Systems Software Support Matrix available at support.dell.com/manuals.
Installation For complete installation and deployment instructions, see the "Dell OpenManage Deployment Toolkit User's Guide." Installation Prerequisites Before installing DTK components, ensure that you have: The DTK ISO image available at support.dell.com. A workstation that has: o 512 MB RAM o A writable CD drive and CD-writing software (optional) o Network access A minimum BIOS version is recommended on some of the platforms for all the DTK options to work correctly.
The "--devseq" option is present only if you have an available, bootable hard-disk partition. If this option is present in the configuration file, but not present on your system, you will receive a usage error. You may need to reboot your system for certain options to be enabled. Dell recommends you use the "reboot" command on shell prompt or press the "Ctrl+Alt+Del" keys. It is required to perform a warm reboot after applying the syscfg settings changes on Dell PowerEdge yx2x systems.
DTK does not support Non RAID (Volume) mode on S100/S300 controller. S300 controller Cachepolicy setting is "Not Applicable". Hence VD created with different cachepolicy settings from OROM utility will be displayed as "Not Applicable". USB keys should not be mounted to the /tmp directory. Inside the /tmp directory, create a new directory and mount the USB to this. On Dell PERC H310 controllers, conversion of a RAID Capable Disk to Non-RAID disk and vice versa is not supported using raidcfg.
VLAN objects (cfgNicVLanEnable, cfgNicVLanId, and cfgNicVLanPriority) displayed using the local RACADM command "racadm getconfig -g cfgLanNetworking" or VLAN objects generated in the configuration file using the local RACADM command "racadm getconfig -f " do not contain the leading "#" symbol which indicates that they are read-only. Operating System Installation Issues Installation of legacy Red Hat Enterprise Linux operating systems may fail due to lack of support for new hardware.
Global Support For information on technical support, visit dell.com/contactus. For information on documentation support, visit support.dell.com/manuals. On the Manuals page, click Software ‐>Systems Management. Click on the specific product on the right‐side to access the documents. Information in this document is subject to change without notice. © 2012 Dell Inc. All rights reserved. Reproduction of these materials in any manner whatsoever without the written permission of Dell Inc. is strictly forbidden.
