Owner's Manual

o Emulex OCe14102-UX-D Dual Port 10Gb SFP+ CNA
o Emulex OCm14102-U3-D Dual Port 10Gb KR Blade Mezz
o Emulex OCm14102-U2-D Dual Port 10Gb KR Blade NDC
o Emulex OiCm14104-UX-D Quad Port 10Gb DA/SFP+ Rack NDC
• Deprecated support for the following operating systems:
• SUSE Linux Enterprise Server 10 SP4
• Red Hat Enterprise Linux 6.4 (64–bit)
• SUSE Linux Enterprise Server 11 SP2
NOTE: For the list of supported operating systems and Dell servers, see the Dell Systems Software
Support Matrix at dell.com/openmanagemanuals.
Important Notes
This product includes software developed by the OpenSSL Project for use in the OpenSSL Toolkit
(http://www.openssl.org/
).
SYSCFG
Some options may not be present on all systems, which may be due to the BIOS version or hardware
feature set. The usage information generated by running SYSCFG without arguments shows only those
options that are valid for your system.
The "--devseq" option is present only if you have an available, bootable hard-disk partition. If this option
is present in the configuration file, but not present on your system, you will receive a usage error.
To enable certain options, to reboot your system. Dell recommends you use the "reboot" command on
shell prompt or press the "Ctrl+Alt+Del" keys.
It is required to perform a warm reboot after applying the syscfg settings changes on Dell PowerEdge
12G systems.
If you perform operations that change the "--redmem" option, reboot your system immediately. It is
applicable to both command line and "--infile" usage.
NOTE: Additionally, the "--redmem" option should not be issued with any other command and should
be immediately followed by a system reboot. This is important when you develop scripts that can alter
the "--redmem" setting.
For options that use text strings such as username, password, hostname, and community string, using
characters such as <space>, "<," ">," "|," "=" on the command line can be misinterpreted by the command
line parser and may cause errors. To avoid such errors, use only alphanumeric characters.
If you set the username using syscfg username option, Serial Over Lan (SOL) access for the
corresponding user will be enabled by default. You can disable SOL access for a user using "syscfg
solaction --userid=<userid> --action=disable" command.
The maximum reliably supported baud rates (--solbitrate) are:
o 57600 for PowerEdge 9G systems without Dell Remote Access Controller 5 (DRAC 5).
o 115200 for PowerEdge 9G systems with DRAC 5.
o If you enter an unsupported baud rate, you may receive an error, "Parameter out of range."
The legacy attribute values enable and disable are also supported for 12G systems for backward
compatibility. In future releases these arguments might be deprecated. Try to use the values displayed in
help message for BIOS options for 12G server.
RAIDCFG
When creating virtual disks, the chunk (stripe) size is always in KBs. Do not specify any units of measure
for the chunk size.