Owner's Manual

• SUSE Linux Enterprise Server 11 SP2
NOTE: For the list of supported operating systems and Dell servers, see the Dell Systems Software
Support Matrix at dell.com/openmanagemanuals.
Important Notes
This product includes software developed by the OpenSSL Project for use in the OpenSSL Toolkit
(http://www.openssl.org/
).
SYSCFG
Some options may not be present on all systems, which may be due to the BIOS version or hardware
feature set. The usage information generated by running SYSCFG without arguments shows only
those options that are valid for your system.
The "--devseq" option is present only if you have an available, bootable hard-disk partition. If this
option is present in the configuration file, but not present on your system, you will receive a usage
error.
It is required to perform a warm reboot after applying the syscfg settings changes on Dell PowerEdge
12G systems.
If you perform operations that change the "--redmem" option, reboot your system immediately. It is
applicable to both command line and "--infile" usage.
NOTE: Additionally, the "--redmem" option should not be issued with any other command and
should be immediately followed by a system reboot. This is important when you develop scripts that
can alter the "--redmem" setting.
For options that use text strings such as username, password, hostname, and community string,
using characters such as <space>, "<," ">," "|," "=" on the command line can be misinterpreted by the
command line parser and may cause errors. To avoid such errors, use only alphanumeric characters.
If you set the username using syscfg username option, Serial Over Lan (SOL) access for the
corresponding user will be enabled by default. You can disable SOL access for a user using "syscfg
solaction --userid=<userid> --action=disable" command.
The maximum reliably supported baud rates (--solbitrate) are:
o 57600 for PowerEdge 9G systems without Dell Remote Access Controller 5 (DRAC 5).
o 115200 for PowerEdge 9G systems with DRAC 5.
o If you enter an unsupported baud rate, you may receive an error, "Parameter out of range."
The legacy attribute values enable and disable are also supported for 12G systems for backward
compatibility. In future releases these arguments might be deprecated. Try to use the values
displayed in help message for BIOS options for 12G server.
DTK 4.4 does not boot on Dell PowerEdge T100. PowerEdge T100 has a BIOS version that is
incompatible with the current HAPI drivers.
RAIDCFG
When creating virtual disks, the chunk (stripe) size is always in KBs. Do not specify any units of measure
for the chunk size.
When providing multiple physical disks for the "create virtual disk" command, do not separate the disks
with spaces.
For example, "-ad=1:4, 1:5" causes an error. The correct way to input multiple physical disks is "-
ad=1:4,1:5,1:6" or "-ad=1:4:0,1:5:0,1:6:0".
If you change the controller mode from SCSI to RAID mode, data loss may occur. Back up any data you
require before changing the modes.