Quick Reference Guide

Example 2:
A:>syscfg --syspwd=<asyspassword> --
oldsyspwd=<currentpassword>
The old password entered is incorrect. The new
password will not be set. Please try again.
Applicable Systems All PowerEdge systems prior to PowerEdge 12G systems.
--opticaldrivectrl
Valid Arguments enable, disable
Description
Enables or disables the optical CD-ROM controller.
Example:
A:>syscfg --opticaldrivectrl=enable
opticaldrivectrl=enable
Applicable Systems All PowerEdge systems prior to PowerEdge 12G systems.
--remflashmedia
Valid Arguments
read-only
Description
Displays the redundancy status of internal dual SD module. The
status can be:
• Full — Secure digital card (SD) 1 and 2 are functioning properly.
• Lost — Either any of the secure digital cards or both are not
functioning properly.
The option also displays the status of the individual SD cards as
follows:
• Active — The card is used for secure digital reads.
• Standby — The card is receiving a copy of all secure digital reads.
• Failed — An error is reported during a secure digital read or write.
• Absent — No secure digital media is detected.
• Offline — At boot, card identification signature is different from
the non-volatile storage value or card is the destination of a
copying operation that is in progress.
• Write Protected — The card is write-protected.
Example:
A:>syscfg --remflashmedia
Internal Dual SD ModuleRedundancy=Lost
SD1 status=Absent
SD1 status=Active
Applicable Systems
PowerEdge R810, R815, R910, and M910 systems
111