Quick Reference Guide

Error Code Message
235 PCIe Link Speed can be set to either 2 or 3 i.e. PCIe
Generation 2.0 or 3.0.
236 PCIe Link Speed could not be retrieved for this RAID
controller.Please check if the controller has the PCIe link
speed capability.
237 Please reset the controller before doing any further
operation.
238 Boot Mode can be set to 0 (BIOS stop on error), 1 (BIOS
continue on error), 2 (Headless continue on error)
239 Boot Mode could not be set for the RAID controller.
240 Enable Auto Import can be set to 0 (No) or 1 (Yes).
241 Enable Auto Import property could not be set for the RAID
controller.
242 Invalid array disk list.
243 Source or destination disk is in invalid state. Make sure that
the source disk is in online state, destination disk is in
ready state, and the size of the destination disk is greater
than or equal to the size of the source disk.
244 Operation not allowed. Cannot set the array disk state to
online.
245 Operation not allowed. Cannot set the array disk state to
offline.
246 Invalid encrypted disk for the instant secure erase operation.
247 Sector drives 512B and 4KB must not be combined while creating
a virtual disk.
248 Hot spare sector size for the virtual disk is not matching.
249 sectorsize parameter is not found.
250 Warning! Cannot assign global hotspare. Input array disk can
act as a hotspare only for virtual disks with matching sector
size (4KB or 512B) and supported T10 PI capability. Use "-
force" option to discard the warning.
251 Force option is invalid for this operation on the specified
controller.
252 Input values for vdiskprotectioninfo and vdpi are 1 and 0.
253 vdiskprotectioninfo or vdpi option is not available on the
controller.
254 Input array disks or hotspares are not PI-capable.
209