Quick Reference Guide

• On 12G and later systems
: AutoVolt, Volt15V
Description
Sets the DIMM voltage selection. When set to AutoVolt(default
value), the system automatically sets the voltage to the optimal
setting based upon the DIMM capability and the installed DIMM
population. This option also enables setting the system DIMM voltage
to a higher (1.5V) setting if the DIMMs support multiple voltages and
have been set to a lower voltage.
NOTE: Volt15V represents 1.5 Volt.
Example:
A:>syscfg --dimmvoltage=auto
dimmvoltage=auto
Applicable Systems PowerEdge 12G and later systems.
--MemTest/--memtest
Valid Arguments
• On systems prior to 12G
: enable, disable
• On 12G and later systems
: Enabled, Disabled
Description
Enables or disables the POST extended memory test.
Example:
A:>syscfg --memtest=disable
memtest=disable
Applicable Systems All PowerEdge systems.
--NodeInterleave/--nodeinterleave
Valid Arguments
• On systems prior to 12G
: enable, disable
• On 12G and later systems
: Enabled, Disabled
Description
Enables node interleaving, if the system is configured with matching
memory. If set to disable (default), the system supports Non-
Uniform Memory (NUMA) architecture memory configurations. This
field is active only if the memory configuration can support node
interleaving.
NOTE: The nodeinterleave option is same as memintleave
option. For more information, see --memintleave.
Example:
A:>syscfg --nodeinterleave=enable
nodeinterleave=enable
Applicable Systems All PowerEdge systems.
44