Reference Guide

--floppy
Option
--floppy
Valid Arguments auto, off, readonly
Description
Sets the diskette drive controller to auto, off, or readonly. This option
is available on all supported systems that have a supported diskette
drive. This option can be replicated
Example:
A:>syscfg --floppy=auto
floppy=auto
Applicable Systems All PowerEdge systems prior to PowerEdge 12G systems.
--formfactor
Valid Arguments
read-only
Description
Displays the geometry of PowerEdge Blade systems. The option can
have the following values: halfheight (the Blade systems occupies 1
slot of the chassis), halfheight, dualwide (the Blade system occupies
2 horizontal slots of the chassis), fullheight (the Blade system
occupies 2 vertical slots of the chassis), fullheight, dualwide (the
Blade system occupies 4 slots of the chassis).
NOTE: On 12G systems, the option will have an additional value,
quarterheight (the Blade systems occupies half slot of the
chassis).
Example:
A:>syscfg --formfactor=fullheight, dualwide
formfactor=fullheight, dualwide
Applicable Systems
All PowerEdge blade systems including 12G systems.
--hddfailover
Valid Arguments
off, on
Descriptionoff
Specifies the device in the Hard Disk Drive Sequence menu that has
not been attempted in the boot sequence. When set to on, all
devices are attempted in an order in which they are configured.
When set to off, only the first device in the hard disk sequence is
attempted. This option can be replicated.
Example:
A:>syscfg --hddfailover=on
hddfailover=on
Applicable Systems All PowerEdge systems prior to PowerEdge 12G systems.
106