Reference Guide

Example:
A:>syscfg --inteltxt=enable
inteltxt=enable
NOTE: To enable the Intel TXT option in a supported processor,
make sure that the:
• Virtualization technology in Processor setting is enabled.
• TPM module is installed and initialed as OK by BIOS.
• TPM security in System security is set to on with pre-boot
measurements.
• User password is not set.
Applicable Systems All PowerEdge 11G and later systems with Intel processors.
--NmiButton/--nmibutton
Valid Arguments
• On systems prior to 12G
: enable, disable
• On 12G and later systems
: Enabled, Disabled
Description
Enables or disables the Non-Maskable Interrupt (NMI) button on the
front panel. The NMI button can be used to alert the operating
system in certain cases.
NOTE: This option configures Baseboard Management
Controller (BMC) and Remote Access Controller (RAC) settings.
Example:
A:>syscfg --nmibutton=enable
nmibutton=enable
Applicable Systems PowerEdge 11G and later systems
--PasswordStatus/--pwdlock
Valid Arguments
• On systems prior to 12G
: lock, unlock
• On 12G and later systems
: Locked, Unlocked
Description
Locks the system password. To prevent the system password from
being modified, set this option to lockedand enable setup password.
This field also prevents the system password from being disabled by
the user while the system boots.
Example:
A:>syscfg --pwdlock=lock
pwdlock=lock
Applicable Systems All PowerEdge systems.
84