CLI Guide

Mandatory
Options and
Arguments
Optional
Parameters
Valid Parameters
Arguments
Description
-sf or
secureflag
0, 1
Creates a secured virtual disk on
controllers with encryption capability
and encryption key.
Example:
A:>raidcfg -ctrl -ac=cvd
-c=2
-ad=1:4,1:8 -sf=1
RAIDCFG Command successful!
Enumerating Array Disks
The following table lists the RAIDCFG options, parameters, and pre-defined arguments for enumerating
array disks (hard-drives).
NOTE: You can also use pdisk or -pd instead of adisk or -ad to specify an array disk.
Table 16. Enumerating Array Disks (Hard Drives)
Mandatory
Options and
Arguments
Optional
Parameters
Valid Parameters/
Arguments
Description
-ad -c=id or
adisk
controllerid=i
d
NA NA
Lists all the array disks attached to the
specified RAID controller. This option
combination is mandatory.
NOTE: The following example
displays the output of a Series 7
controller.
NOTE: The software controller does
not display the NegSpeed,
CapSpeed, Certified and
Supported parameters.
Example:
A:>raidcfg -ad -c=2
Controller: PERC H710P Adapter
****** Physical Drive ******
Vendor: DELL(tm)
Model: ST3300657SS
Protocol: SAS
Media: HDD
NegSpeed: 6144 Mbps
CapSpeed: 6144 Mbps
Certified: YES
Supported: YES
Location: 0:7:1
Size: 285568 MB (278 GB)
Avail: 285568 MB (278 GB)
179