Migration from Dell Lifecycle Controller Integration Version 3.3 for Microsoft System Center Configuration Manager to OpenManage Integration Version 7.0 for Microsoft System Center 1 August 2017 Rev.
Notes, cautions, and warnings NOTE: A NOTE indicates important information that helps you make better use of your product. CAUTION: A CAUTION indicates either potential damage to hardware or loss of data and tells you how to avoid the problem. WARNING: A WARNING indicates a potential for property damage, personal injury, or death. Copyright ©2017 Dell Inc. or its subsidiaries. All rights reserved. Dell, EMC, and other trademarks are trademarks of Dell Inc. or its subsidiaries.
Contents Chapter 1: Introduction................................................................................................................. 4 Chapter 2: Saving user data from DLCI for SCCM......................................................................... 5 Chapter 3: Uninstalling DLCI for SCCM......................................................................................... 6 Chapter 4: Setting up OMIMSSC....................................................................................
1 Introduction This technical document describes how user can migrate from Dell Lifecycle Controller Integration Version 3.3 for Microsoft System Center Configuration Manager (DLCI for SCCM) to OpenManage Integration Version 7.0 for Microsoft System Center (OMIMSSC). OMIMSSC does not support upgrade from DLCI for SCCM, and hence manual migration of data is required.
2 Saving user data from DLCI for SCCM Before migrating from DLCI for SCCM to OMIMSSC, ensure that you capture all the user details from DLCI for SCCM. The details to be captured are listed below. 1. Note down the credentials (user name and password) used to discover servers in DLCI for SCCM. 2. Share path of boot images or supporting files—WIM files can be used in OMIMSSC to re-create boot images. 3. Save a local copy of the purchased license file.
3 Uninstalling DLCI for SCCM Uninstall DLCI for SCCM to proceed further with the migration. For more information, see Uninstalling Dell Lifecycle Controller Integration for Configuration Manager section of Dell Lifecycle Controller Integration Version 3.3 for Microsoft System Center Configuration Manager Installation Guide.
4 Setting up OMIMSSC Once you uninstall DLCI for SCCM, install and launch OMIMSSC. To configure OMIMSSC, perform the following steps. 1. Setting up OMIMSSC Appliance— create and configure a VM for OMIMSSC. 2. Launch admin portal to download OMIMSSC components. 3. Download and install, Integration Gateway and OMIMSCC console extension for SCCM. 4. Enroll SCCM with OMIMSSC. 5. Launch OMIMSSC console extension for SCCM.
5 Recreating data in OMIMSSC This section provides information on how to migrate or re-create the user data captured in Saving user data from DLCI for SCCM. 1. Credential profile for discovery—create a Device Type Credential profile with the saved credential profile to discover servers that were already discovered in DLCI for SCCM. You can discover Dell EMC servers by synchronizing SCCM with OMIMSSC or using their iDRAC IP address.
6 Feature mapping and migration data Feature mapping between DLCI for SCCM and OMIMSSC and data migration information: Table 1.
Table 1.
is installed. Create boot images with the copied WIM file in OMIMSSC. Integration for Microsoft System Center User's Guide. Lifecycle controller (LC) boot media LC boot media created has references to boot image created in DLCI for SCCM. Hence the image cannot be exported in OMIMSSC. For information about creating LC boot media, see Creating Lifecycle Controller boot media section in OpenManage Integration for Microsoft System Center User's Guide.
7 Accessing support content from the Dell EMC support site Access supporting content related to an array of systems management tools using direct links, going to the Dell EMC support site, or using a search engine. ● Direct links: ○ For Dell EMC Enterprise Systems Management and Dell EMC Remote Enterprise Systems Management—https:// www.dell.com/esmmanuals ○ For Dell EMC Virtualization Solutions—https://www.dell.com/SoftwareManuals ○ For Dell EMC OpenManage—https://www.dell.
