Messages Reference Guide

Introduction 13
Discrete voltage state: <State> Specifies the state of the voltage sensor, for example:
Discrete voltage state: Good
Fan sensor value:
<Reading> Specifies the fan speed in revolutions per minute (RPM) or
On/Off, for example:
Fan sensor value (in RPM): 2600
Fan sensor value: Off
Log type:
<Log type> Specifies the type of hardware log, for example:
Log type: ESM
Memory device bank location:
<Bank name in chassis>
Specifies the name of the memory bank in the system that
generated the message, for example:
Memory device bank location: Bank_1
Memory device location:
<Device
name in chassis>
Specifies the location of the memory module in the chassis,
for example:
Memory device location: DIMM_A
Number of devices required for
full redundancy:
<Number>
Specifies the number of power supply or cooling devices required to
achieve full redundancy, for example:
Number of devices required for full
redundancy: 4
Possible memory module event
cause:
<list of causes>
Specifies a list of possible causes for the memory module event,
for example:
Possible memory module event cause: Single bit
warning error rate exceeded
Single bit error logging disabled
Power Supply type:
<type of
power supply>
Specifies the type of power supply, for example:
Power Supply type: VRM
Previous redundancy state was:
<State>
Specifies the status of the previous redundancy message,
for example:
Previous redundancy state was: Lost
Previous state was:
<State> Specifies the previous state of the sensor, for example:
Previous state was: OK (Normal)
Processor sensor status:
<status>
Specifies the status of the processor sensor, for example:
Processor sensor status: Configuration error
Table 1-2. Event Description Reference (continued)
Description Line Item Explanation