User's Manual

Using the Storage Management Service 153
omconfig Resume Check Consistency
Use the following omconfig command syntax to resume a check consistency after it has been paused.
Complete Syntax
omconfig storage vdisk action=resumecheckconsistency controller=id
vdisk=id
where id is the controller ID and virtual disk ID as reported by the omreport command. To obtain these
values, enter omreport storage controller to display the controller IDs and then enter omreport storage
vdisk controller=ID to display the IDs for the virtual disks attached to the controller.
Example Syntax
For example, to resume a check consistency on virtual disk 4 on controller 1, enter:
omconfig storage vdisk action=resumecheckconsistency controller=1
vdisk=4
omconfig Delete Virtual Disk
Use the following omconfig command syntax to delete a virtual disk.
NOTICE: Deleting a virtual disk destroys all information including file systems and volumes residing on the virtual
disk. You may receive a warning message if you attempt to delete the system or boot partition. However, this
warning message is not generated in all circumstances. You should be certain that you are not deleting the system
or boot partition or other vital data when using this command.
Complete Syntax
omconfig storage vdisk action=deletevdisk controller=id vdisk=id
where id is the controller ID and virtual disk ID as reported by the omreport command. To obtain these
values, enter omreport storage controller to display the controller IDs and then enter omreport storage
vdisk controller=ID to display the IDs for the virtual disks attached to the controller.
In some circumstances, you may receive a warning message if you attempt to delete a virtual disk
containing the system or boot partition. You can override this warning by using the [force=yes] parameter.
In this case, the syntax is as follows:
omconfig storage vdisk action=deletevdisk controller=id vdisk=id
[force=yes]
Example Syntax
For example, to delete virtual disk 4 on controller 1, enter:
omconfig storage vdisk action=deletevdisk controller=1 vdisk=4