User's Manual

162 Using the Storage Management Service
omconfig Rebuild Array Disk
Use the following omconfig command syntax to rebuild a failed array disk. Rebuilding a disk may take
several hours. If you need to cancel the rebuild, use the Cancel Rebuild task. For more information, see
the online help.
Complete Syntax
omconfig storage adisk action=rebuild controller=id adisk=<ADISKID>
where id is the controller ID. The <ADISK> variable specifies the array disk.
To obtain these values, enter omreport storage controller to display the controller IDs and then enter
omreport storage adisk controller=ID to display the IDs for the array disks attached to the controller.
Example Syntax
In this example, you want to rebuild array disk 3 on connector 0 of controller 1. On a SAS controller, the
array disk resides in enclosure 2.
Example for SCSI, SATA, and ATA Controllers:
To rebuild the array disk described in this example, enter:
omconfig storage adisk action=rebuild controller=1 adisk=0:3
Example for SAS Controllers:
To rebuild the array disk described in this example, enter:
omconfig storage adisk action=rebuild controller=1 adisk=0:2:3
omconfig Cancel Rebuild Array Disk
Use the following omconfig command syntax to cancel a rebuild that is in progress. If you cancel a
rebuild, the virtual disk remains in a degraded state. See the online help for more information.
Complete Syntax
omconfig storage adisk action=cancelrebuild controller=id adisk=
<ADISKID>
where id is the controller ID. The <ADISK> variable specifies the array disk.
To obtain these values, enter omreport storage controller to display the controller IDs and then enter
omreport storage adisk controller=ID to display the IDs for the array disks attached to the controller.