Users Guide

Remote Access Service 91
Adding and Configuring DRAC Users
NOTE: You must have Admin privileges in Server Administrator to use the Remote Access Service.
The DRAC can store information for up to 16 users. The Remote Access Service provides security by
requiring a user to provide a user name and password prior to establishing a remote connection.
The Remote Access Service can also provide paging services to notify users if the system crashes, loses power,
or experiences a defined list of other events. Paging services are only available for DRAC III cards.
NOTE: Some configuration capabilities are available only on systems with DRAC III, DRAC III/XT, ERA, and ERA/O,
and not on systems with DRAC 4. To configure DRAC 4, use the Launch Remote Connect Interface option in the
RAC Properties window. See the Dell Remote Access Controller 4 User's Guide for more information.
To create a DRAC user, perform the following steps:
1
Click the Main System Chassis object on the Server Administrator home page, and then click the
Remote Access Controller object.
2 Click the Users tab.
The
Remote Access Controller Users window appears.
3 Click Add .
The
Add Remote Access Controller User window appears.
4 Type a user name in the User Name field.
5 Type a new password in the New Password field.
6 Type the new password again in the Confirm Password field.
7 Configure numeric paging (for DRAC III users only):
a Click the check box next to Enable Numeric Paging and enter a pager number in the Pager
Number
field.
b Enter the numeric message in the Numeric Message field that you want the DRAC to send when
it receives certain events.
8 Configure e-mail paging:
a Click the check box next to Enable Email Paging and enter an e-mail address in the Email
Address
field.
b Enter the message in the Message field that you want the DRAC to send when it receives certain events.
9 Configure alphanumeric paging (for DRAC III users only):
a Click the check box next to Enable Alpha-Numeric Paging and enter a pager number in the
Pager Number field.
b Select the alphanumeric protocol used by the pager's service provider, 7E0 or 8N1 .
c Select the pager's baud rate, 300 or 1200 .