Users Guide

92 Remote Access Service
d Enter the message in the Custom Message field that you want the DRAC to send when it receives
certain events.
e Enter the pager's PIN in the Pager ID field, and then, if required, enter a pager password in the
Pager Password field.
f Click Apply Changes at the bottom of the window.
10 Under Severity Configuration , specify the trap and the severity that the trap must have to trigger a
paging action from the DRAC.
Traps enable you to configure the DRAC to respond to alert conditions from the system's ESM
hardware or to other conditions such as operating system crashes or power failures.
The first (left-most) column of check boxes corresponds to the severity level
Informational , the
second column corresponds to the severity level
Warning , and the third column corresponds to the
severity level
Critical . The last seven events can only report the severity level Informational .
11 Click Apply Changes and then click OK to save the alert, paging, and user configuration to the Server
Administrator data repository.
Server Administrator returns to the
Users tab. The user you just created and configured is displayed in
the
User Name list.
Configuring an Existing DRAC User
NOTE: You must have Admin privileges in Server Administrator to use the Remote Access Service.
To configure a DRAC user, perform the following steps:
1
Click the Main System Chassis object on the Server Administrator home page, and then click the
Remote Access Controller object.
2 Click the Users tab.
The
Remote Access Controller Users window appears.
3 Click the user name for the user you want to configure.
4 Change the password:
a Click the check box next to Change Password and type a new password in the Password field.
b Type the new password again in the Confirm Password field.
5 Configure numeric paging (for DRAC III users only):
a Click the check box next to Enable Numeric Paging and enter a pager number in the Pager
Number
field.
b Enter the numeric message in the Numeric Message field that you want the DRAC to send when
it receives certain events.