User's Manual

160 Using the Storage Management Service
omreport Connector Status
omreport Enclosure Status
Table 9-7. omreport Connector Commands
Required Command Levels (1, 2, 3) Optional name=value pairs Use
omreport storage connector Displays all connectors present on all
controllers on the system.
NOTE: This command works only when
the controller id is specified.
controller=id
where id is the controller
number. For example:
controller=0
Displays the connector on the specified
controller.
controller=id
where id is the controller
number. For example:
controller=0
connector=id
where id is the connector
number. For example:
connector=0
Displays information for the specified
connector on the controller.
Table 9-8. omreport Enclosure Commands
Required Command Levels (1, 2, 3) Optional name=value pairs Use
omreport storage enclosure Displays property information for
all enclosures attached to the
system.
controller=id enclosure=
<ENCLOSUREID>
where id is the controller number
and the enclosure number. For
example: controller=0
enclosure=2
Displays the specified enclosure
and its components.