User's Manual

48 omreport: Viewing System Status Using the Instrumentation Service
omreport chassis biossetup
Use the omreport chassis biossetup command to view BIOS setup parameters that are normally available
only during system boot.
Ty p e :
omreport chassis biossetup
Table 4-2 displays the BIOS setup parameters that are available:
NOTE: Not all the parameters are displayed. Only those BIOS setup properties that are configured during system
boot are displayed.
Table 4-2. BIOS Setup Parameters
Parameters Description
Bezel Displays whether the bezel removal intrusion check during system
reboot is enabled or disabled.
Bootsequence Displays the device that is used to boot the system.
Console Redirection Displays if the BIOS screen is redirected over a particular serial port
or if it is turned off.
Console Redirection After Boot Displays whether console redirection after system reboot is enabled
or disabled.
Diskette Displays whether the diskette is disabled, auto enabled, or read only.
Demand Based Power
Management (DBS)
Displays whether DBS is enabled or disabled on the system.
Dual NIC Displays whether NIC 1 and NIC 2 with PXE is enabled or disabled.
External Serial Connector Displays whether the external serial connector is mapped to COM
port 1 or COM port 2 or a Remote Access Device.
Console Redirection Failsafe Baud
Rate
Displays the setting for console redirection failsafe baud rate.
IDE Displays whether the drive is enabled or disabled.
IDE Primary Drive 0 Displays whether the device is automatically detected and enabled
or if the device is disabled.
IDE Primary Drive 1 Displays whether the device is automatically detected and enabled
or if the device is disabled.
Intrusion Displays whether the intrusion check is enabled or disabled during
system boot.
Mouse Displays whether the mouse is enabled or disabled.
NIC and NIC 2 Displays whether the first and second NICs are enabled (with or
without PXE) or disabled during system boot.