User's Manual

80 omconfig: Managing Components Using the Instrumentation Service
omconfig chassis bmc
NOTE: This command will be phased-out in future releases. It will be replaced by the command omconfig chassis
remoteaccess.
Use the omconfig chassis bmc command to configure:
• The BMC on a local area network (LAN)
• The serial port for BMC
• The BMC on a serial over LAN connection
• Terminal settings for the serial port
• Advanced settings for a serial over LAN connection
• Information on a BMC user
NOTE: You have to enter the user ID to configure user information.
attribute=uausb setting=on | backonly | off on: Enables the user-accessible
USB port(s)
backonly: Enables only the user accessible
USB port(s) at the back of the system.
off: Disables the user-accessible
USB port(s).
attribute=usb setting=enabled | disabled enabled: Enables the USB port(s).
disabled: Disables the USB port(s).
NOTE: Depending on your system’s
hardware, only one of the two attributes
usb and usbb is available for configuring
the USB port(s).
attribute=usbb setting=enabled |
enabledwithbios| disabled
enabled: Enables the USB port(s) during
system boot, without BIOS support.
enabledwithbios: Enables the USB
port(s) during the system boot, with
BIOS support.
disabled: Disables the USB port(s)
during system boot.
NOTE: Depending on your system’s
hardware, only one of the two attributes
usb and usbb is available for configuring
the USB port(s).
Table 5-2. BIOS Setup (continued)
name=value pair 1
attribute=
name=value pair 2
setting=
Description