Users Guide

Instrumentation Service 67
Properties
Subtab: Intrusion
Under the Properties tab, you can view the chassis intrusion status.
Alert Management
Subtabs: Alert Actions | SNMP Traps
Under the Alert Management tab, you can:
• View current alert actions settings and set the alert actions that you want to be performed in the event
that the intrusion sensor returns a warning or failure value.
• View current SNMP trap alert thresholds and set the alert threshold levels for the intrusion sensor. The
selected traps will be triggered if the system generates a corresponding event at the selected severity level.
Memory
Clicking the Memory object allows you to manage your system's memory devices. Server Administrator
monitors the memory device status for each memory module present in the monitored system. Memory
device prefailure sensors monitor memory modules by counting the number of ECC memory
corrections. Server Administrator also monitors memory redundancy information if your system supports
this feature. The Memory object action window can have the following tabs, depending on the user's
group privileges: Properties, Alert Management, and Diagnostics.
Properties
Subtab: Memory
Under the Properties tab, you can view memory attributes, memory device details, and memory device status.
NOTE: If a system with spare bank memory enabled enters a redundancy lost state, it may not be apparent which
memory module is the cause. If you cannot determine which DIMM to replace, see the switch to spare memory
bank detected log entry in the ESM system log to find which memory module failed.
Alert Management
Subtabs: Alert Actions | SNMP Traps
Under the Alert Management tab, you can:
• View current alert actions settings and set the alert actions that you want to be performed in the event
that a memory module returns a warning or failure value.
• View current SNMP trap alert thresholds and set the alert threshold levels for memory modules. The
selected traps will be triggered if the system generates a corresponding event at the selected severity level.
Diagnostics
Subtabs: Select | Review | Status | Results | Hardware Changes | Settings | Scheduled Tasks
Under the Diagnostics tab, you can:
• View and select to run all available diagnostics tests for components installed in your system.
• Review the selected tests.