Reference Guide

572 Traps
Date and time of action: < Date
and time
>
Specifies the date and time that an automatic server recovery
action was performed, for example:
Date and time of action:
Fri May 30 23:55:44 2003.
Device location: <Location in
chassis>
Specifies the location of the device in the specified chassis, for
example:
Device location: Mem Card A
Discrete current state:
<State> Specifies the state of the current sensor, for example:
Discrete current state: Good
Discrete temperature state:
<State>
Specifies the state of the temperature sensor, for example:
Discrete temperature state: Good
Discrete voltage state:
<State> Specifies the state of the voltage sensor, for example:
Discrete voltage state: Good
Fan sensor value: <
Reading > Specifies the fan speed in revolutions per minute (RPMs) or
On/Off, for example:
Fan sensor value (in RPM): 2600
Fan sensor value: Off
Log type: <
Log type > Specifies the type of hardware log, for example:
Log type: Embedded Server Management (ESM)
Memory device bank location:
<
Bank name in chassis >
Specifies the name of the memory bank in the system that
generated the message, for example:
Memory device bank location: Bank_1
Memory device location:
<
Device name in chassis >
Specifies the location of the memory module in the chassis,
for example:
Memory device location: DIMM_A
Number of devices required for
full redundancy: <
Number >
Specifies the number of power supply or cooling devices required
to achieve full redundancy, for example:
Number of devices required for full
redundancy: 4
Possible memory module event
cause:
<list of causes>
Specifies a list of possible causes for the memory module event,
for example:
Possible memory module event cause: Single bit
warning error rate exceeded
Single bit error logging disabled
Table 25-1. Trap Description Reference (continued)
Description Line Item Explanation