Read me

file:///T|/htdocs/SOFTWARE/svradmin/5.4/en/readme/readme_sa.txt[10/23/2012 1:42:59 PM]
8. Log in to DRAC 4, and navigate to the Virtual Media link.
The plug-in is installed and ready to use.
9. At this point, delete the "~/rac4vm.xpi" file.
* The cfgDNSServer1 and cfgDNSServer2 properties of group
cfgLanNetworking may be set to identical values while swapping
addresses. Some performance may be lost temporarily during the
swapping. The cfgLanNetworking group is configured using the
"racadm config" command.(132894)
----------------------------------------------------------------------
ISSUES FOR DRAC III, DRAC III/XT, ERA, AND ERA/O
----------------------------------------------------------------------
Download the readme for your RAC type from support.dell.com for
the latest information on all known issues.
* Remote Access Dial-Up Settings: If you change a DRAC III modem
"Dial Mode" setting to "Tone" or "Pulse" using Server Administrator,
IT Assistant displays the opposite setting.
----------------------------------------------------------------------
ISSUES FOR ALL OPERATING SYSTEMS
----------------------------------------------------------------------
* Server Administrator user interface and commands related to "local
authentication enable" are not applicable for RAC firmware 3.20.
The Active Directory authentication feature replaces the "local
operating system authentication" feature in this version of
firmware. Due to this change, the following commands will return
errors:
"racadm localauthenable"
"omconfig rac authentication"
* Due to fluctuations in the watchdog timer, the "Last Crash
Screen" may not be captured when the Automatic System Recovery is
set to a value of less than 30 seconds. To ensure correct functioning
of the Last Crash Screen feature, set the System Reset Timer to at
least 30 seconds.
* The cfgDNSServer1 and cfgDNSServer2 properties of group
cfgLanNetworking may be set to identical values while swapping
addresses. Some performance may be lost temporarily during the
swapping. The cfgLanNetworking group is configured using the
"racadm config" command.(132894)
* The remote access controller uses FTP protocol to perform some of
the Dell OpenManage commands. If a firewall is installed in the
system, it may cause these commands to fail.
The following Server Administrator CLI commands use FTP protocol to
communicate with the RAC: