User's Manual

104 omconfig: Managing Components Using the Instrumentation Service
To clear the contents of the command log, type:
omconfig system cmdlog action=clear
or
omconfig servermodule cmdlog action=clear
To clear the contents of the ESM log, type:
omconfig system esmlog action=clear
or
omconfig servermodule esmlog action=clear
omconfig system pedestinations/omconfig servermodule pedestinations
Use the omconfig system pedestinations or omconfig servermodule
pedestinations command to set IP addresses for alert destinations.
Table 4-22 shows the valid parameters for the command.
NOTE: You can either specify the index and IP address as parameters together or
you can set the only community string as a parameter.
omconfig system platformevents/omconfig servermodule platformevents
Use the omconfig system platformevents or omconfig servermodule
platformevents command to configure shutdown action, if any, to be taken for a
specific platform event. You can also enable or disable platform event filter
alert generation.
NOTICE: If you set a platform event shutdown action to anything other than "none" or
"power reduction", your system will forcefully shutdown when the specified event
occurs. This shutdown is initiated by firmware and is carried out without first shutting
down the operating system or any of the applications running on your system.
Table 4-22. omconfig system pedestinations/omconfig servermodule pedestinations
name=Value Pair Description
destenable=true | false true: Enables an individual platform event filter destination after a
valid IP address has been set.
false: Disables an individual platform event filter.
index=number Sets the index for the destination.
ipaddress=ip address Sets the IP address for the destination.
communitystr=text Sets the text string that acts as a password and is used to authenticate
SNMP messages sent between the BMC and the destination
management station.