User's Manual

Using the Storage Management Service 135
omreport Connector Status
Table 6-7describes the syntax for the omreport Connector Commands.
omreport Enclosure Status
Table 6-8 describes the syntax for the omreport Enclosure Commands.
Table 6-7. omreport Connector Commands
Required Command Levels
(1, 2, 3)
Optional name=value
pairs
Use
omreport storage connector Displays all connectors present on all
controllers on the system.
NOTE: This command works only
when the controller ID is specified.
controller=id
where id is the controller
number. For example:
controller=0
Displays the connector on the
specified controller.
controller=id
where id is the controller
number. For example:
controller=0
connector=id
where id is the connector
number. For example:
connector=0
Displays information for the specified
connector on the controller.
Table 6-8. omreport Enclosure Commands
Required Command Levels
(1, 2, 3)
Optional name=value pairs Use
omreport storage enclosure Displays property information for all
enclosures attached to the system.
controller=id enclosure=
<ENCLOSUREID>
where id is the controller
number and
ENCLOSUREID is the
enclosure number. For
example: controller=0
enclosure=2
Displays the specified enclosure and
its components.