User's Manual

170 Using the Storage Management Service
omconfig Format Virtual Disk
Use the following omconfig command syntax to format a virtual disk.
Complete Syntax
omconfig storage vdisk action=format controller=id
vdisk=id
where id is the controller ID and virtual disk ID as reported by the omreport
command. To obtain these values, enter omreport storage controller to display
the controller IDs and then enter omreport storage vdisk controller=ID to
display the IDs for the virtual disks attached to the controller.
Example Syntax
To format virtual disk 4 on controller 1, enter:
omconfig storage vdisk action=format controller=1
vdisk=4
omconfig Reconfiguring Virtual Disks
You can reconfigure a virtual disk to change the virtual disk’s RAID level or
increase its size by adding physical disks. On some controllers, you can also
remove physical disks.
Complete Syntax
omconfig storage vdisk action=reconfigure
controller=id vdisk=id raid=<c| r0| r1| r1c| r5|
r6| r10> size=<size> pdisk=<PDISK>
Example Syntax
To reconfigure virtual disk 4 to a size of 800 MB, use RAID-5 and physical
disks 0 through 3 on connector 0 of controller 1. On a SAS controller, the
physical disks reside in enclosure 2.