User's Manual

172 Using the Storage Management Service
Example Syntax
To change the read policy of virtual disk 4 on controller 1 to no-read-ahead,
enter:
omconfig storage vdisk action=changepolicy
controller=1 vdisk=4 readpolicy=nra
omconfig Rename Virtual Disk
Use the following omconfig command syntax to rename a virtual disk.
NOTE: On a CERC SATA 1.5/2s controller, you cannot change the default name of a
virtual disk.
Complete Syntax
action=rename controller=id vdisk=id name=<string>
where id is the controller ID and virtual disk ID as reported by the omreport
command and <string> is the new name for the virtual disk. To obtain the
values for controller ID and virtual disk ID, enter omreport storage controller
to display the controller IDs and then enter omreport storage vdisk
controller=ID to display the IDs for the virtual disks attached to the controller.
Example Syntax
To rename virtual disk 4 on controller 1 to vd4, enter:
omconfig storage vdisk action=rename controller=1
vdisk=4 name=vd4
omconfig Physical Disk Commands
The following sections provide the omconfig command syntax required to
execute physical disk tasks.
Table 6-23. omconfig Physical Disk Commands
Required Command Levels
(1, 2, 3)
Optional name=value pairs
omconfig storage pdisk
action=blink controller=id pdisk=<PDISKID>
action=unblink controller=id pdisk=<PDISKID>
action=remove controller=id pdisk=<PDISKID>
action=initialize controller=id pdisk=<PDISKID>