User's Manual

Using the Storage Management Service 175
omconfig Prepare to Remove Physical Disk
Use the following omconfig command syntax to prepare a physical disk for
removal:
Complete Syntax
omconfig storage pdisk action=remove controller=id
pdisk=<PDISKID>
where id is the controller ID. The <PDISK> variable specifies the physical
disk.
To obtain these values, enter omreport storage controller to display the
controller IDs and then enter omreport storage pdisk controller=ID to
display the IDs for the physical disks attached to the controller.
Example Syntax
In this example, you want to prepare physical disk 3 on connector 0 of
controller 1 for removal. On a SAS controller, the physical disk resides in
enclosure 2.
Example for SCSI, SATA, and ATA Controllers
To prepare to remove the physical disk described in this example, enter:
omconfig storage pdisk action=remove controller=1
pdisk=0:3
Example for SAS Controllers
To prepare to remove the physical disk described in this example, enter:
omconfig storage pdisk action=remove controller=1
pdisk=0:2:3