User's Manual

176 Using the Storage Management Service
omconfig Initialize Physical Disk
Use the following omconfig command syntax to initialize a physical disk.
Complete Syntax
omconfig storage pdisk action=initialize
controller=id pdisk=<PDISKID>
where id is the controller ID. The <PDISK> variable specifies the physical
disk.
To obtain these values, enter omreport storage controller to display the
controller IDs and then enter omreport storage pdisk controller=ID to
display the IDs for the physical disks attached to the controller.
Example Syntax
In this example, you want to initialize physical disk 3 on connector 0 of
controller 1. On a SAS controller, the physical disk resides in enclosure 2.
Example for SCSI, SATA, and ATA Controllers
To initialize the physical disk described in this example, enter:
omconfig storage pdisk action=initialize
controller=1 pdisk=0:3
Example for SAS Controllers
To initialize the physical disk described in this example, enter:
omconfig storage pdisk action=initialize
controller=1 pdisk=0:2:3