User's Manual

28 omreport: Viewing System Status Using the Instrumentation Service
info U, P, A Shows a status summary for main system
chassis components.
intrusion U, P, A Shows the status of the system’s intrusion
sensor(s).
leds U, P, A Shows the properties you have set for light-
emitting diodes to flash under various alert
conditions.
memory U, P, A Shows properties of your system's memory
arrays.
nics U, P, A Shows the number of NICs installed in
your system, NIC vendor, NIC description,
IP address, and connection status.
ports U, P, A Shows the properties for your system’s
parallel and serial ports, such as I/O
address, IRQ level, connector type, and
maximum speed.
processors U, P, A Shows properties of your system’s
processors, including speed, manufacturer,
and processor family.
pwrmonitoring U, P, A Shows properties of power consumption.
pwrsupplies U, P, A Shows properties of power supplies.
remoteaccess U, P, A Shows general information on remote
access.
slots U, P, A Shows properties of your system’s
expansion slots and other slot types.
temps U, P, A Shows the status and thresholds for the
system temperature sensors.
volts U, P, A Shows the status and thresholds for the
system voltage sensors.
storage U, P, A See "Using the Storage Management
Service."
system/serv
ermodule
U, P, A Shows a high-level summary of system
components.
Table 3-2. Command Level 1, Level 2, and Level 3 for omreport (continued)
Command
Level 1
Command
Level 2
Command
Level 3
User
Privilege
Required
Use