User's Manual

66 omconfig: Managing Components Using the Instrumentation Service
thrmshutdown A Sets the severity level at which a thermal
event triggers a system shutdown.
webserver A Starts or stops the Web server.
chassis/
mainsystem
biossetup A Configures the behavior of specific system
components controlled by the BIOS.
bmc A Configures remote access information.
NOTE: This command is phased-out in this
releases. It is replaced by the remoteaccess
command.
fans P, A Configures fan probe warning thresholds
by default or by value.
NOTE: You cannot change threshold
values on embedded server management
(ESM3) and Dell™ PowerEdge™ x8xx
systems.
fancontrol P, A Allows you to optimize fan speed for
maximum cooling or quiet operation.
frontpanel A Configures the Power button and
Nonmasking Interrupt (NMI) button if
present on the system.
info P, A Allows you to set an initial value, or to edit
the value for, asset tag or chassis name.
leds P, A Specifies when to flash a chassis fault LED
or chassis identification LED, and allows
you to clear the LED for the system's hard
drive.
memorymode A Enables or disables the spare bank and
mirroring memory modes, and also specify
which mode to use.
pwrmonitoring P, A Configures power consumption
information and thresholds.
remoteaccess A Configures remote access information.
Table 4-2. omconfig Command Level 1, Level 2, and Level 3 (continued)
Command
Level 1
Command
Level 2
Command
Level 3
User
Privilege
Required
Use