User's Manual

omconfig: Managing Components Using the Instrumentation Service 71
attribute=dualnic setting=off | onpxeboth |
onpxenone | onpxenic1 |
onpxenic2
off: Disables the network interface
controller’s
( NIC).
onpxeboth: Enables both the NICs are PXE.
onpxenone: PXE is not enabled on either of
the NICs.
onpxenic1: Enables PXE on NIC 1.
onpxenic2: Enables PXE on NIC 2.
attribute=
embhypvisor
setting=enabled |
disabled
enabled: Enables embedded hypervisor.
disabled: Disables embedded hypervisor.
attribute=extserial setting=com1 | com2 |
rad
com1: Maps external serial connector to
COM 1.
com2: Maps external serial connector to
COM 2.
rad: Maps external serial connector to remote
access device.
attribute=fbr setting=9600 | 19200 |
57600 | 115200
9600: Sets the console redirection failsafe baud
rate to 9600 bits per second.
19200: Sets the console redirection failsafe baud
rate to 19200 bits per second.
57600: Sets the console redirection failsafe
baud rate to 57600 bits per second.
115200: Sets the console redirection failsafe
baud rate to 115200 bits per second.
attribute=ide setting=on | off
force=true
on: Enables this device.
off: Disables this device.
force=true: Verification of setting change.
attribute=idepridrv setting=off | auto off: Disables the device.
auto: Detects and enables the device
automatically.
attribute=intrusion setting=enable | disable enable: Enables the intrusion check during
system boot. If the system also has bezel
intrusion checking, then the intrusion option
checks for removal of the bezel of the system.
disable: Disables the intrusion check during
system boot.
Table 4-3. BIOS Setup Settings (continued)
name=value pair 1
attribute=
name=value pair 2
setting=
Description