Compatibility Guide

140 Historical Release Information for Legacy Systems
Operating Systems
• Microsoft Windows NT Server 4. x with SP 4 or later
• Microsoft Windows 2000 Server family (includes Windows 2000 Server
and Windows 2000 Advanced Server)
• Novell NetWare 4.
x or 5. x
• Red Hat Linux 7.0; Kernel version: 2.2.16; Red Hat Linux SNMP agent:
ucd-snmp version 4.1.2-8smux
New in Server Agent Version 4.3.0
This release adds support for the following Dell systems:
• PowerEdge 2500
• PowerEdge 2550
Server Agent 4.3.0 Resolved Issues
• Hung server alerts for PowerEdge 8450 systems
When you configure the hung server action for a Dell PowerEdge 8450 system,
the system either performs a system reset or a recycle system power action.
• PowerEdge 350 issues
This release addressed the following Dell PowerEdge 350 issues that were
originally addressed by Dell OpenManage Server Agent 4.2.0 Update 1:
– Changes thresholds for the -12 volt (V) voltage probe on the system board.
These new thresholds prevent erroneous probe failures and warnings.
– Corrects erroneous fan failure reports in the event log.
– Corrects system crashes at start-up caused by incorrect event log
record length.
– Disables the chassis identification feature.
• Dell PowerVault™ 2
xx S SCSI disk systems and SNMP
This release addresses the following PowerVault 2
xx S SCSI disk system
issue that was originally addressed by Server Agent 4.2.0 Update 1:
– Allows Dell PowerEdge systems attached to the PowerVault 2
xx S SCSI
disk system to respond to SNMP requests for information. Under
certain rare circumstances, some Dell systems with PowerVault 2
xx S
attached were not responding to SNMP requests.