Messages Reference Guide

Index 235
The initialization sequence of
SAS components failed
during system startup. SAS
management and monitoring
is not possible., 191
The non-RAID SCSI driver
version is older than the
minimum required level.See
the Readme file for the
validated driver version., 136
The NVRAM has corrupt
data., 197
The NVRAM has corrupted data.
The controller is
reinitializing the
NVRAM., 196
The only hot spare available is a
SAS disk. SAS disks cannot
replace SATA disks., 153
The only hot spare available is a
SATA disk. SATA disks
cannot replace SAS
disks., 153
The Patrol Read corrected a
media error., 173
The patrol read has
resumed., 180
The Patrol Read has started., 163
The Patrol Read has
stopped., 164
The Patrol Read is paused., 180
The Patrol Read mode has
changed., 163
The Patrol Read rate has
changed., 161
The physical disk blink has
ceased., 167
The physical disk blink has
initiated., 166
The physical disk Clear
operation failed., 173
The physical disk Clear
operation has
completed., 173
The physical disk Clear
operation has started., 166
The physical disk has been
started., 168
The physical disk is not
certified., 210
The physical disk is not
supported., 154
The physical disk is too small to
be used for a rebuild., 187
The physical disk rebuild has
resumed., 175
The power supply cable has been
inserted., 195
The power supply is switched
on., 195
The RAID controller firmware
and driver validation was not
performed. The
configuration file cannot be
opened., 135